Here's how:
Start by unscrewing both doors from the cabinet.
Then, use a thin bar to carefully pry off each stile. If necessary, cut the nails with a hacksaw blade.
Reattach the stiles to the cabinet with no-mortise hinges. These are easy-to-install hinges that don't require recesses - you simply screw them in place.
Once the stiles are hinged to the cabinet, reattach the doors to the stiles with the original hinges.
Customize the Interior
I added four key components to my armoire: a CPU tray, a surge-protector power strip and wire grommet, an adjustable keyboard slide, and a speaker shelf. I
made the pullout CPU tray from 22 mm plywood, and attached it to the cabinet floor with two centre-mount, full-extension drawer slides. This is simple. After screwing the slides to the bottom of the plywood tray, screw the mating piece of each drawer slide to the cabinet. Align the drawer slides and push the tray until the slides engage. To help absorb vibration, top the tray with a sheet of thin foam rubber or thick fabric.
The next step is to mount a grommet and install a plug adaptor; this will greatly reduce the number of wires you'll need to snake outside of the armoire. Trace the grommet on the lower back of the armoire, and cut to the line with a jigsaw. Attach the plastic grommet by simply pushing it into the hole.
Mount the plug adaptor and feed its cord through the grommet.
Add a Keyboard Slide
When shopping for a keyboard slide [try kitchen cabinet manufacturers] and install the slide - making the shelf it hangs from. If you're lucky, you'll be able to use one of the original armoire shelves. If not, make one out of 22 mm plywood or edge-joined solid boards.
Turn the shelf upside down and attach the keyboard slide with screws. You can mount the keyboard slide in the centre of the shelf, but if you keep it off to one side, it will create a little extra storage space under the other half of the shelf.
Now screw cleats to the interior sides and back for supporting the shelf. Attach each cleat with glue and drywall screws, then set the shelf down onto the cleats.
To hold the two speakers, I cut a deep shelf from one of the original armoire shelves. Position the shelf above the monitor. Attach cleats to each side of the cabinet with glue and brads. I cut the cleats from a length of moulding, but any narrow wood strip would work. Bore holes in the cabinet back for the speaker wires.
Finally, I cut two rectangular holes in the cabinet top and installed vents to help exhaust hot air generated by the computer equipment.
|
